DELL 8132 ユーザーズマニュアル

GVRP Commands

•

timer_value — Timer values in centiseconds. The range is 10-100 for join, 

20-600 for 

leave, and 200-6000 for leaveall.

The default timer values are as follows:

• Join timer — 20 centiseconds
• Leave timer — 60 centiseconds
• Leaveall timer — 1000 centiseconds

Interface Configuration (gigabitethernet, port-channel, tengigabitethernet, 

fortygigabitethernet) mode

The following 

relationships for the various timer values must be maintained:

• Leave time must be greater than or equal to three times the join time.
• Leaveall time must be greater than the leave time.

Set the same GARP timer values on all Layer 2-connected devices. If the 

GARP timers are set differently on Layer 2-connected devices, the GARP 

application will not operate successfully.
The 

timer_value setting must be a multiple of 10.

The following example sets the leave timer for port 1/0/8 to 90 centiseconds.

console (config)# interface gigabitethernet 1/0/8

console (config-if-1/0/8)# garp timer leave 90

Use the gvrp enable (global) command in Global Configuration mode to 

enable GVRP globally on the switch. To disable GVRP globally on the switch, 

use the no form of this command. 

2CSPC4.X8100-SWUM102.book  Page 459  Friday, March 15, 2013  8:56 AM