DELL 8132 ユーザーズマニュアル

ページ / 1818
IP Addressing Commands
489
20
IP Addressing Commands
Interfaces on the PowerConnect switches support a variety of capabilities to 
support management of the switch. In addition to performing switching and 
routing of network traffic, PowerConnect switches act as a host for 
management of the switch. Commands in this category allow the network 
operator to configure the local host address, utilize the embedded DHCP 
client to obtain an address, resolve names to addresses using DNS servers, and 
detect address conflicts on the local subnet.
There are two management interface types on PowerConnect switches. In-
band interfaces allow management of the switch through the network 
switching/routing interfaces. Out-of-band management is always through the 
dedicated out-of-band interface. The serial port on the stack master provides 
a direct console interface supporting a CLI. In-band management interfaces 
can employ a variety of protection mechanisms including VLAN assignment 
and Management ACLs. The out-of-band port does not support such 
protection mechanisms and, therefore, it is recommended that the out-of-
band interface only be connected to a physically segregated management 
network.
Commands in this Chapter
This chapter explains the following commands:
2CSPC4.X8100-SWUM102.book  Page 489  Friday, March 15, 2013  8:56 AM