DELL 8132 ユーザーズマニュアル

iSCSI Optimization Commands

AE Priority = priority configured for iSCSI PFC (the VPT value above). This 

TLV is sent in addition to any Application Priority TLV information received 

from the configuration source. If the configuration source is sending iSCSI or 

FCoE application priority information, it is not necessary to enable iscsi cos 

to send the iSCSI Application Priority TLV.

In the following example, iSCSI is globally enabled.

console(config)#iscsi enable

Use the iscsi target port command in Global Configuration mode to 

configure iSCSI port(s), target addresses and names. To delete iSCSI port(s) 

or target ports, use the no form of this command.

iscsi target port 

tcp-port-1 [tcp-port-2.… tcp-port-16

 

[address 

ip-address] 

[name 

targetname]

no iscsi target port 

tcp-port-1 [tcp-port-2.… tcp-port-16 [address ip-address]

tcp-port 

TCP port number or list of TCP port numbers on which iSCSI 

target(s) listen to requests. Up to 16 TCP ports can be defined 

in the system in one command or by using multiple commands.

ip-address

IP address of the iSCSI target. When the no form is used, and 

the tcp port to be deleted is one bound to a specific IP address, 

the address field must be present.

2CSPC4.X8100-SWUM102.book  Page 552  Friday, March 15, 2013  8:56 AM