DELL 8132 ユーザーズマニュアル
Spanning Tree Commands
747
console(config)#interface gigabitethernet 1/0/5
console(config-if-1/0/5)#spanning-tree cost 35000
spanning-tree disable
Use the spanning-tree disable command in Interface Configuration mode to
disable spanning-tree on a specific port. To enable spanning-tree on a port,
use the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
no spanning-tree disable
Default Configuration
By default, all ports are enabled for spanning-tree.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet,
fortygigabitethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example disables spanning-tree on 1/0/5.
console(config)#interface gigabitethernet 1/0/5
console(config-if-1/0/5)#spanning-tree disable
spanning-tree forward-time
Use the spanning-tree forward-time command in Global Configuration
mode to configure the spanning-tree bridge forward time, which is the
amount of time a port remains in the listening and learning states before
entering the forwarding state.
To reset the default forward time, use the no form of this command.
To reset the default forward time, use the no form of this command.
2CSPC4.X8100-SWUM102.book Page 747 Friday, March 15, 2013 8:56 AM