DELL 8132 ユーザーズマニュアル
788
VLAN Commands
Default Configuration
The default for this command is 802.1Q. The default S-TAG TPID, when
double-tagging is enabled, is 0x88A8. The default C-TAG TPID when double
vlan tagging is enabled is 0x8100.
Command Mode
Global Configuration, Interface Configuration mode
User Guidelines
This command configures the TPID value on the outer VLAN (S-VLAN).
The global configuration form of the command configures all physical and
port-channel interfaces on which double VLAN tunneling is enabled to use
the specified ethertype. Use the
command in Interface
mode to enable double VLAN tagging on an interface. The interface form of
the command enables/disables the use of the ethertype on the specific
interface. The ethertype used in the interface form of the command must use
the same ethertype as specified in the global configuration form of the
command. The inner vlan tag (C-TAG) is configured using the switchport
command in interface configuration mode.
Example
The following example displays configuring Double VLAN tunnel for vman
EtherType.
console(config)#dvlan-tunnel ethertype vman
interface vlan
The vlan routing command is deprecated in favor of the interface vlan
command. Use the interface vlan command in Global Configuration mode to
enter VLAN Interface Configuration mode.
Syntax
interface vlan {vlan-id} [nsf-index]
2CSPC4.X8100-SWUM102.book Page 788 Friday, March 15, 2013 8:56 AM