DELL 8132 ユーザーズマニュアル

VLAN Commands

Interface Configuration (gigabitethernet, port-channel, tengigabitethernet, 

fortygigabitethernet) mode

This command removes the port from the previous VLAN membership and 

adds it to the specified VLAN. The no form of the command sets the port 

VLAN membership to VLAN 1.

The following example configures interface gi1/0/8 to operate in access mode 

with a VLAN membership of 23. Received untagged packets are processed on 

VLAN 23. Received packets tagged with VLAN 23 are also accepted. Other 

received tagged packets are discarded.

console(config)#interface gigabitethernet 1/0/8

console(config-if-1/0/8)#switchport access vlan 23

Use the switchport general forbidden vlan command in Interface 

Configuration mode to forbid adding specific VLANs to a general mode port. 

To revert to allowing the addition of specific VLANs to the port, use the 

remove parameter of this command.

switchport general forbidden vlan {add 

vlan-list | remove vlan-list}

• add 

vlan-list — List of valid VLAN IDs to add to the forbidden list. 

Separate nonconsecutive VLAN IDs with a comma and no spaces. Use a 

hyphen to designate a range of IDs.

•

 vlan-list — List of valid VLAN IDs to remove from the forbidden 

list. Separate nonconsecutive VLAN IDs with a comma and no spaces. Use 

a hyphen to designate a range of IDs.

All VLANs allowed.

2CSPC4.X8100-SWUM102.book  Page 806  Friday, March 15, 2013  8:56 AM