DELL NT499 ユーザーズマニュアル
222
Adding and Replacing Parts
7 Slide the sliding-plate lever to the right to release the shoulder screw and
slide the drive or Media Card Reader out of the 3.5-inch drive bay.
Installing a Floppy Drive or Media Card Reader (Tower Computer)
NOTICE:
In a tower configuration with 4 hard drives, there can only be one floppy
drive or Media Card Reader which must be installed in the lower 3.5-inch drive bay.
In this case, the 4th hard drive (which must be a SATA drive) will occupy the upper
3.5-inch drive bay.
In this case, the 4th hard drive (which must be a SATA drive) will occupy the upper
3.5-inch drive bay.
1 Follow the procedures in "Before You Begin" on page 143.
2 Remove the computer cover (see "Removing the Computer Cover" on
2 Remove the computer cover (see "Removing the Computer Cover" on
3 Remove the front panel (see "Removing the Front Panel" on page 154).
4 If you are installing a new floppy drive or Media Card Reader, remove the
4 If you are installing a new floppy drive or Media Card Reader, remove the
drive-panel insert (see "Removing a Drive-Panel Insert" on page 218) and
remove the shoulder screws from the inside of the drive-panel insert.
Attach the screws to the new drive.
remove the shoulder screws from the inside of the drive-panel insert.
Attach the screws to the new drive.