Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. DELL
  4. NT499
  5. ユーザーズマニュアル

DELL NT499 ユーザーズマニュアル

ダウンロード
ページ / 290
48
About RAID Configurations
Intel Matrix Storage Console. Both methods require that you set your 
computer to RAID-enabled mode before starting any of the RAID 
configuration procedures in this document.
Setting Your Computer to RAID-Enabled Mode
1 Enter System Setup (see "Entering System Setup" on page 81).
2 Press the up- and down-arrow keys to highlight Drives, then press 
<Enter>.
3 Press the up- and down-arrow keys to highlight SATA Operation, then 
press <Enter>.
4 Press the left- and right-arrow keys to highlight RAID On, press <Enter>, 
and then press <Esc>.
 
NOTE: 
5 Press the left- and right-arrow keys to highlight Save/Exit, and press 
<Enter> to exit System Setup and resume the boot process.
Configuring Your Computer for RAID Using the Intel
®
 RAID Option 
ROM Utility
 
NOTE: 
Although any size of drives may be used to create a RAID configuration 
when using the Intel RAID Option ROM utility, ideally the drives should be of equal 
size. In a RAID level 0 configuration, the size of the configuration will be the size of 
the smallest drive multiplied by the number (two) of drives in the configuration. In a 
RAID level 1 configuration, the size of the configuration will be the smaller of the 
two drives used.
Creating a RAID Level 0 Configuration
 
NOTICE: 
You will lose any data on your hard drives when you create a RAID 
configuration using the following procedure. Back up data that you want to keep 
before continuing.
 
NOTE: 
Use the following procedure only if you are reinstalling your operating 
system. Do not use the following procedure to migrate an existing storage 
configuration to RAID level 0 configuration.