JVC LYT1282-001A ユーザーズマニュアル
24
EN
Master Page: Left-Heading0
CAPTURING VIDEO
When a camcorder is connected to the PC with a USB cable, the video from the camcorder can be recorded
on the PC’s hard drive instead of on tape or in a memory card (Only for D.S.C. equipped models) — real-time
capture.
on the PC’s hard drive instead of on tape or in a memory card (Only for D.S.C. equipped models) — real-time
capture.
NOTE:
There are differences in the following procedures whether your camcorder is equipped with D.S.C. (Digital
Still Camera) features or not.
There are differences in the following procedures whether your camcorder is equipped with D.S.C. (Digital
Still Camera) features or not.
1
Make sure that no cassette is in the camcorder.
(Only for D.S.C. non-equipped models)
2
Connect the camcorder to the PC with a USB cable.
● Refer to “Connections (Windows
®
)” or “Connections (Macintosh)” in “SOFTWARE INSTALLATION
AND USB CONNECTION GUIDE”.
3
Set the camcorder’s VIDEO/MEMORY Switch to “MEMORY”.
(Only for D.S.C. equipped
models)
4
Set the camcorder’s Power Switch to “A” or “M” while pressing down the Lock Button
located on the switch.
located on the switch.
The camcorder is now on.
“
“
” appears on the camcorder’s LCD monitor.
● If “
” does not appear, install [USB Video Streaming driver]. Refer to “Software Installation
(Windows
®
)” and “Software Installation (Macintosh)” in “SOFTWARE INSTALLATION AND USB
CONNECTION GUIDE”.
NOTE:
The procedure is different when reading or writing a memory card. (Only for D.S.C. equipped models)
The procedure is different when reading or writing a memory card. (Only for D.S.C. equipped models)
5
Click [Start], go to [All Programs] or [Programs] – [PIXELA] – [ImageMixer], and then click
[ImageMixer Ver.1.7].
[ImageMixer Ver.1.7].
● For Macintosh, double-click the [ImageMixer] icon on the PC.
ImageMixer starts up.
Capturing video in real time
CONTINUED ON NEXT PAGE
M4D3+DSC_Soft.book Page 24 Tuesday, December 16, 2003 2:08 PM