HP (Hewlett-Packard) B8U11UT#ABA ユーザーズマニュアル
Stand
The stand is secured with two captive Torx screws. You must remove a plastic cover to gain access
to the screws. You must remove the access panel to remove the stand.
to the screws. You must remove the access panel to remove the stand.
To remove the stand:
1.
2.
Remove the access panel (see
).
3.
Push the release button (1) on the bottom of the stand and pull the back of the stand off (2).
Figure 7-9
Removing the back of the stand
4.
Push the base of the stand down (1), and loosen the two captive Torx screws securing the stand
to the chassis (2).
to the chassis (2).
Figure 7-10
Releasing the stand
38
Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis