HP (Hewlett-Packard) C5J37AWABA ユーザーズマニュアル
Converter board
The converter board is located on the left side of the computer (viewed from behind) under the main
rear cover. It is secured with two Torx screws and has two connectors.
rear cover. It is secured with two Torx screws and has two connectors.
Use the same converter spare part for all display panels; however, you must change jumper settings
on the board based on the display panel.
on the board based on the display panel.
Figure 6-45
Converter board location
To remove the converter board:
1.
2.
Remove the access panel (see
).
3.
Disconnect the two cables from the board (1).
NOTE:
Be careful not to damage the cables when disconnecting them from the board. Do not
pull on the wires.
58
Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis