HP (Hewlett-Packard) C5J37AWABA ユーザーズマニュアル
Fan
The fan is located near the middle of the computer and is secured with three Torx screws. You have
to remove the metal plate to remove the fan..
to remove the metal plate to remove the fan..
To remove the fan assembly:
1.
Prepare the computer for disassembly (see
2.
Remove the access panel (see
).
3.
).
4.
Remove the lower panel (see
).
5.
Remove the metal plate (see
).
6.
Disconnect the fan cable from the system board connector labeled CHFAN (1).
7.
Remove the three Torx screws that secure the fan to the computer (2).
8.
Remove the fan from the computer (3).
Figure 6-63
Removing the fan
To install the fan assembly, reverse the removal procedures.
NOTE:
To avoid damaging the rubber screw grommets installed around the captive screws, when
installing the fan, push down on the fan assembly before you tighten the screws. Make sure the
grommets are positioned correctly before tightening the screws.
grommets are positioned correctly before tightening the screws.
Fan
75