HP (Hewlett-Packard) Desktop PCs プリント

Part Replacement Instructions

D

E

F

C

B

A

Connect the power cable (E) and the data cable 

(F), place the hard disk drive cage over the two 

bottom screws (C) in 

the chassis, insert the two 

top screws (D), and then 

tighten all the screws. 

Align and insert the hooks on the vertical cover 

(B) into the holes on the back of the chassis, and 

reaching beneath 

the display, hold down 

the lever (A) while sliding 

the vertical cover down 

and into place. Release 

the lever. 

On the hard disk drive cage, loosen the two bottom 

screws (C) three turns, remove the two top screws 

(D), lift the cage up off the bottom screws, and then 

disconnect the power 

cable (E) and the data 

cable (squeeze the 

connector) (F).

Remove the four screws (G) from the cage, and lift 

the hard disk drive from the cage. Place the new 

hard disk drive into the cage and insert the four 

screws.

D

E

F

C

G

G

Raise the display (monitor) to see release lever (A). 

Unplug the computer.

Ground yourself.

Holding down the lever (A), pull up the vertical 

cover (B), and remove it from the chassis.

A

B

A

Note: Before doing any work inside 

your computer, ground yourself by 

touching a metal part of the computer 

frame.

CAUTION: This product contains 

components that are easily damaged 

by Electrostatic Discharge (ESD). To 

reduce the chance of ESD damage, 

work over a non-carpeted floor, use 

a static dissipative work surface (like 

a conductive foam pad), and wear 

an ESD wrist strap that is connected 

to a grounded surface, like the metal 

frame of the PC.