HP (Hewlett-Packard) E1Z89UTABA ユーザーズマニュアル

Push the green release lever on the right rear side of the drive toward the center of the drive (1),

then slide the drive forward and out of the bay (2).

Prepare the computer for disassembly (

).

Remove the access panel (

Remove the front bezel (

). If you are installing a drive in a bay covered by

a bezel blank, remove the bezel blank. See 

 for more

information.

Before the new optical drive can be used, the release latch must be attached.

a. Peel the backing off the adhesive on the release latch.

b. Without allowing the release latch to touch the optical drive, carefully align the holes on the

release latch with the pins on the side of the optical drive. Make sure the release latch is

oriented properly.

Insert the pin at the front of the optical drive into the hole at the end of the release latch, and

press firmly.

68

Chapter 5   Removal and replacement procedures: Tower (TWR)