HP (Hewlett-Packard) H2D81US ユーザーズマニュアル

Visit 

 to learn which graphics cards are supported in the workstation,

how much memory each graphics card includes, and graphics card power requirements.

To install an expansion card:

Disconnect power from the workstation (see 

Remove the side access panel (see 

Push the expansion card retention clamp levers down on the outside of the chassis to release the
retention clamp   as shown in the figure below.

  Removing the slot cover

Remove the expansion card slot cover by pulling it up, out of the chassis 

2

.

Grasp the slot cover between two fingers—one from the inside of the chassis, and one from

the outside.

Angle the card into the expansion card guide.

Align the PCIe card keyway with the slot key, and then firmly seat the card in the slot as shown
next  .

Close the expansion card retention clamp by rotating it downward  .

If the PCI retention clamp does not close, ensure that all cards are properly seated, and then try
again.

If required by the card, connect the auxiliary power cable to the card (not illustrated).

ENWW

Removing and installing components

95