HP (Hewlett-Packard) H2D81US ユーザーズマニュアル

To install an optical disk drive:

Disconnect power from the workstation (see 

Remove the side access panel (see 

Remove the front bezel (see 

).

Lift the green release lever   and slide the optical disk drive into the bay until it is stopped by the
release latch as shown in the figure below.

Release the latch and continue sliding the drive until the latch closes and engages the drive 

2

.

  Installing the optical disk drive

During installation the adjacent drive or filler may move slightly. It might be necessary to

slide and align both devices to get the release latch to close and engage both devices.

Connect the power and data cables to the drive as shown in the following figure. (See the service
label on the Side access panel for component locations.)

ENWW

Removing and installing components

79