HP (Hewlett-Packard) H2D81US ユーザーズマニュアル
Rear system fan assembly
NOTE:
Read
before servicing this component.
This section describes how to remove and install the rear system fan assembly.
Removing the rear system fan assembly
To remove the rear system fan assembly:
1.
2.
Remove the side access panel (see
3.
Disconnect the rear system fan assembly cable from the system board as shown in the following
figure.
figure.
Figure 5-18
Disconnecting fan wires
4.
Remove the four screws from the rear of the chassis
2
, and then pull the fan assembly inward and
then up out of the chassis.
Installing the rear system fan assembly
To install the rear system fan assembly, reverse these steps.
84
Chapter 5 Replacing components
ENWW