Wasp Bar Code WLR8900 ユーザーズマニュアル
5
In order to configure Wasp WLR 8900/8905 Scanners, you must familiarize
yourself with the setup procedures on the following pages. The default settings
of the Wasp WLR 8900/8905 Scanners are identified on each page and clearly
marked using an asterisk (*).
yourself with the setup procedures on the following pages. The default settings
of the Wasp WLR 8900/8905 Scanners are identified on each page and clearly
marked using an asterisk (*).
The default settings have been preprogrammed
for the most common bar code configurations. Use the Setup &
Configuration only to customize the Wasp WLR 8900/8905 Scanners
settings. If you need to configure the scanner, the default settings will be
overwritten. All the programmed settings are stored permanently in non-volatile
memory; therefore, your configuration will be maintained even if the keyboard
power to Wasp WLR 8900/8905 Scanners is removed by turning off your PC.
Configuration only to customize the Wasp WLR 8900/8905 Scanners
settings. If you need to configure the scanner, the default settings will be
overwritten. All the programmed settings are stored permanently in non-volatile
memory; therefore, your configuration will be maintained even if the keyboard
power to Wasp WLR 8900/8905 Scanners is removed by turning off your PC.
In order to configure Wasp WLR 8900/8905 Scanners, two basic steps need
to be followed:
to be followed:
(1) Locate the group that contains the options to be changed.
(2) Scan the bar code representing the option to be changed. The scanner will
(2) Scan the bar code representing the option to be changed. The scanner will
sound two beeps.
To change Minimum/Maximum Length:
(1) Scan the Minimum or Maximum Length bar code.
(2) Scan a 2 digit value from the ASCII table on pages 31-34
(3) Scan the Minimum or Maximum Length bar code again.
(2) Scan a 2 digit value from the ASCII table on pages 31-34
(3) Scan the Minimum or Maximum Length bar code again.
Example: To have a minimum length bar code of 1, you must scan a 0 then 1, then scan
the minimum bar code again. To have a maximum length bar code of 10, you must scan
a 1 then 0, then scan the maximum bar code again.
the minimum bar code again. To have a maximum length bar code of 10, you must scan
a 1 then 0, then scan the maximum bar code again.
Chapter 5
Setup & Configuration