Aspire Digital 3810TZG ユーザーズマニュアル

Chapter 2

NOTE: When you are prompted to enter a password, you have three tries before the system halts. Don’t forget 

your password. If you forget your password, you may have to return your notebook computer to your 
dealer to reset it.

Setting a Password

Follow these steps as you set the user or the supervisor password:

1. Use the w andy keys to highlight the Set Supervisor Password parameter and press the e key. The Set 

Supervisor Password box appears:

2. Type a password in the “Enter New Password” field. The password length can not exceeds 8 

alphanumeric characters (A-Z, a-z, 0-9, not case sensitive). Retype the password in the “Confirm New 
Password” field.

IMPORTANT:Be very careful when typing your password because the characters do not appear on the    

screen.

3. Press e.

                After setting the password, the computer sets the User Password parameter to “Set”.

4. If desired, you can opt to enable the Password on boot parameter.

5. When you are done, press u to save the changes and exit the BIOS Setup Utility.

Removing a Password

Follow these steps:

1. Use the w and y keys to highlight the Set Supervisor Password parameter and press the e key. The Set 

Password box appears:

2. Type the current password in the Enter Current Password field and press e.

3. Press e twice without typing anything in the Enter New Password and Confirm New Password fields. The 

computer then sets the Supervisor Password parameter to “Clear”.

4. When you have changed the settings, press u to save the changes and exit the BIOS Setup Utility.

Password on Boot

Defines whether a password is required or 
not while the events defined in this group 
happened. The following sub-options are all 
requires the Supervisor password for 
changes and should be grayed out if the 
user password was used to enter setup.

Disabled or Enabled