AEG PROTECT B. 1500 ユーザーズマニュアル
32
PROTECT B. 3000 / B. 3000 BP
For mounting the 3000 VA UPS in a 19” rack fix the mounting
ears to the UPS and install the unit to the rails. Do the same
for the optional battery module.
ears to the UPS and install the unit to the rails. Do the same
for the optional battery module.
5.2
Additional battery installation setup
PROTECT B. 1500, 2000 und 3000 include external battery
ports that allow connecting additional battery modules. This
provides additional battery runtime.
ports that allow connecting additional battery modules. This
provides additional battery runtime.
Caution:
Connect the battery connectors quickly and
check for a tight fit of the connections.
check for a tight fit of the connections.
PROTECT B. 1500 und B. 2000
There is one external battery port on the UPS and on the
battery pack.
battery pack.
1.
Connect the battery cable to the external battery
port of the rear of UPS.
port of the rear of UPS.
2.
Then connect the supplied battery cable from
extended battery module to the external battery
port on the rear of the UPS.
extended battery module to the external battery
port on the rear of the UPS.
If continuing to add up extended battery packs, repeat
above step.
above step.
100%
FAULT
100%
50%
75%
25%
75%
50%
VOLTAGE RANGE:
220V AC
230V AC
240V AC
OVER LOAD
BAD BAT.
PSDR FAIL
25%
INPUT TYPE:
NORMAL
LINE MODE
BAT. MODE
GENERATOR
WIDE RANGE
TEST
CNFG
ON / OFF
ENTER