AEG 1000 ユーザーズマニュアル
31
EN
Explanations:
1 Power supply (UPS input)
can be locked using the position lock that comes included
2 Option for fixed ground
using extra screw
3 Automatically locking load segment connections
(UPS outputs) for critical loads with highest priority,
permanently directly supplied by the UPS (not manageable)
permanently directly supplied by the UPS (not manageable)
4 Manageable, i.e. via the UPS operating panel and
/ or the
software load segment connections Load circuit 1
(automatically locking)
(automatically locking)
5 Manageable, i.e. via the UPS operating panel and
/ or the
software load segment connections Load circuit 2
(automatically locking)
(automatically locking)
i
Remove the load plugs by pressing the red
button below each output outlet.
button below each output outlet.
6 Separate fuse for the load circuit
for PROTECT D.3000
7 Emergency Power Off,
optionally to be configured as opener or closer
8 Change-over
contact,
potential-free, programmable using the UPS operating panel
9 Vent (Important: Allow for at least 100mm of free space
behind the vent to ensure proper ventilation)
10 USB communication interface
11 RS232 communication interface (sub-D9 jack)
12 Communication slot for optional extension cards:
11 RS232 communication interface (sub-D9 jack)
12 Communication slot for optional extension cards:
Relay card, card for remote On/Off, SNMP, …
i
The USB and the RS232 communication
interfaces rule each other out, i.e. either USB or
RS232. The communication slot, on the other
hand, is dual-monitor enabled, i.e. can be used
parallel to the USB or RS232 interface.
interfaces rule each other out, i.e. either USB or
RS232. The communication slot, on the other
hand, is dual-monitor enabled, i.e. can be used
parallel to the USB or RS232 interface.