Mitsubishi Electronics 700 Series ユーザーズマニュアル

(1) When the operation result up to the OUT instruction is ON, the coil of the timer

turns on and the timer times up to the setting, and when the timer times out
(timing value 

≥ setting), the contact operates as indicated below.

(2) When the operation result up to the OUT instruction turns from ON to OFF, the

timer operates as indicated below.

(3) After a time-out, the contact state of the retentive timer remains unchanged until

the RST instruction is executed.

(4) A negative number (-32768 to -1) cannot be specified for the setting.
(5) If the setting is 0, it is timed as infinity. Hence, the timer does not time out.
(6) Refer to page 81 for the timing method of the timer.

(1) When the operation result up to the OUT instruction turns from OFF to ON, the

present value (count value) is incremented by 1, and when the counter stops
counting (present value = setting), the contact operates as indicated below.

(2) The counter does not count if the operation result remains ON. (Count inputs

need not be converted into pulses.)

(3) After the counter has stopped counting, the count value and contact state remain

unchanged until the RST instruction is executed.

(4) A negative number (-32768 to -1) cannot be specified for the setting. If the setting

is 0, processing is the same as when the setting is 1.

(5) Refer to page 83 for the counting method of the counter.

Executed every scan independently of the operation result up to the OUT instruction.

OUT(T)

N/O contact

Energize

N/C contact

Not energize

100ms timer

OFF

0

Not 

energize

Energize

Not 

energize

Energize

10ms timer
100ms 
retentive timer

OFF

Maintained

Not 

energize

Energize

Energize

Not 

energize

OUT(C)

N/O contact

Energize

N/C contact

Not energize