Atlantis Land A03-PS651 _MX01 ユーザーズマニュアル
OnePower Line Interactive UPS (EN)
A03-PS651 Pag. 20
the UPS. Connect from the “OUT” jack with telephone cable (supplied) or network
cabling (not supplied) to a fax modem or network port.
Connect the supplied interface cable to the RS232 computer interface port on the
back of the UPS. Connect to the computer. See software document for
installation instruction.
cabling (not supplied) to a fax modem or network port.
Connect the supplied interface cable to the RS232 computer interface port on the
back of the UPS. Connect to the computer. See software document for
installation instruction.
1.7 Operation Test
1. Connect the UPS to the wall receptacle.
2. With the UPS plugged in, press and hold the POWER button more
2. With the UPS plugged in, press and hold the POWER button more
than 3 seconds until hearing one short beep sound to switch the UPS
on, then UPS is in the displaying condition. If use UPS for first time,
please let UPS operate for 10 hours emptily to charge battery so that
battery can't be in low capacity.
on, then UPS is in the displaying condition. If use UPS for first time,
please let UPS operate for 10 hours emptily to charge battery so that
battery can't be in low capacity.
3. After switch on UPS, in utility power mode, press POWER button
(within 2 seconds), and UPS perform a self-test on the battery
capacity, renew within 3 seconds.
capacity, renew within 3 seconds.
4. Connect your computer equipment with sockets of the UPS and pull off
the input power cable of the UPS from the wall receptacle to check if the
LED Battery is Orange. Meanwhile, please check if alarm buzzer is
beeping(every 3-5 seconds).Check if the UPS is initiated properly to
support continuous operation.
LED Battery is Orange. Meanwhile, please check if alarm buzzer is
beeping(every 3-5 seconds).Check if the UPS is initiated properly to
support continuous operation.