Mitsubishi Electronics XD3200U ユーザーズマニュアル
EN-9
Using the remote control
30°
30°
30°
30°
20°
10°
10°
20°
10°
10°
20°
20°
Operational range of the remote control
• Keep the remote control photo-sensor out of direct
sunlight or fluorescent lamp light.
• Keep the remote control photo-sensor at least 2 m
(6 feet) away from fluorescent lamps. Otherwise, the
remote control may malfunction.
remote control may malfunction.
• If there is an inverter-operated fluorescent lamp near
the remote control, the remote control operation may
become unstable.
become unstable.
• When you use the remote control too close to the
remote control sensor, the remote control may not work
correctly.
correctly.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Front of projector
Rear of projector
Operate the remote
control within a distance
of 10 m (30 feet) from the
projector, pointing the
light beam at the remote
control photo-sensor (front
or rear) of the projector.
control within a distance
of 10 m (30 feet) from the
projector, pointing the
light beam at the remote
control photo-sensor (front
or rear) of the projector.
When operating the remote control, keep the
distance from the remote control to the projector
via the screen within about 5 m (15 feet). The
operable range of the remote control, however,
depends on the characteristics of the screen.
distance from the remote control to the projector
via the screen within about 5 m (15 feet). The
operable range of the remote control, however,
depends on the characteristics of the screen.
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
remote control is useful for operating in a distance or outside of the operating area.
• For connection, use the pin-pin cable of ø3.5 stereo
type, which is commercially available. However,
some cable may not work correctly.
• When REMOTE OUT terminal on this projector is
connected to the REMOTE IN terminal on the other
projector, the two projectors can be controlled
together by using the remote control.
• When the remote control is connected with remote
control cable, it does not work as a wireless remote
control.
• When using the wired remote control, the laser
beam may be darker. It is normal.
REMOTE IN
REMOTE OUT
REMOTE IN