Panasonic PTVX410ZU ユーザーズマニュアル
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
Æ
page 45) for the operation of the menu screen.
After selecting the item, press
f
asqw
to set.
[STATUS]
You can check the using status of the projector.
Press
1)
as
to select [STATUS].
Press the <ENTER> button.
2)
The [STATUS] screen is displayed.
f
[SIGNAL]
[NAME]
Displays the name of input signal.
[FREQUENCY]
Displays the scanning frequency of input signal.
[RUNTIME]
*
1
[PROJECTOR]
Displays the current usage time of projector.
[LAMP
(ET-)]
[NORMAL]
[ECO1]
[ECO2]
Displays the operation time of lamp in each mode (NORMAL/ECO1/ECO2).
It may differ from the actual runtime under the each setting of [NORMAL]/
[ECO1]/[ECO2] in [LAMP POWER] menu.
And, displays the model no. of the replacement lamp unit for this projector.
[SERIAL NUMBER]
[PROJECTOR]
Displays the serial number of the projector.
The following conversion is required to calculate the rough estimate for lamp replacement.
*1
Formula for lamp replacement time (rough estimate)
A x 1 + B x 0.8 + C x 2/3
A : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [NORMAL]
f
B : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO1]
f
C : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO2]
f
[
COMPUTER2
SELECT]
Set whether to use the
<
COMPUTER 2 IN/1 OUT
>
terminal.
Press
1)
as
to select [
COMPUTER2
SELECT].
Press
2)
qw
to switch the item.
The items will switch each time you press the button.
f
[COMPUTER2 IN]
When input the computer signal.
[COMPUTER1 OUT]
Outputs the signal which have been input <COMPUTER 1 IN> terminal.
Note
The [COMPUTER2 SELECT] will be unavailable when COMPUTER2 is selected as input source.
f
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side to enable
simultaneous control or individual control via a single remote control.
Press
1)
as
to select [PROJECTOR ID].
Press the <ENTER> button.
2)
The [PROJECTOR ID] screen is displayed.
f
66 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu