Mitsubishi Electronics SE2U ユーザーズマニュアル

Introduction

10

Remote Control Effective Range

Infra Red (IR) remote control sensors are located on the front and the back of the projector. 

The remote control must be held at an angle within 30 degrees of the projector’s IR remote 

control sensors to function correctly. The distance between the remote control and the sen-

sors should not exceed 6 meters (19.5 feet). 

Make sure that there are no obstacles between the remote control and the IR sensors on the 

projector that might obstruct the infra-red beam. 

Installing or Replacing the Battery

1.

Pull out the battery holder while sliding the 
lock in the direction of the arrow using a 
pointed stick such as a ball point pen.

2.

Insert the new battery in the holder.

3.

Push the holder into the remote control.

•  

Use of a battery of wrong type may cause 

explosion. Use type CR2025 only.

•  

Dispose of used batteries according to your 

local regulations.

•  

Batteries may explode if misused. Do not recharge, disassemble, or dispose of in fire.

•  

Be sure to handle the battery according to the instructions.  

•  

Load the battery with its positive (+) and negative (-) sides correctly oriented as 

indicated on the remote control. 

•  

Keep batteries out of reach of children and pets. 

•  

Remove the battery, if the remote control is not used for a long time. 

MODE

According to the selected input signal, there are several picture 
setup options available: Presentation mode, Video mode, 
Cinema mode and Lamp Low mode. Refer to page

 25

 for more 

information.

6m

Battery holder

Lock