Toshiba HD-XE1 ユーザーズマニュアル
16
1
Chapter
1
Introduction
Notes
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or
Do not leave the remote control near an extremely hot or
humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
Dispose of batteries in a designated disposal area.
Batteries should always be disposed of with the
Do not disassemble the remote control.
Dispose of batteries in a designated disposal area.
Batteries should always be disposed of with the
environment in mind.
Always dispose of batteries in accordance with applicable
laws and regulations.
If the remote control does not operate correctly, or if the
operating range becomes reduced, replace all batteries
with new ones.
with new ones.
When necessary to replace batteries in the remote
control, always replace all batteries with new ones.
Never mix battery types or use new and used batteries in
combination.
Never mix battery types or use new and used batteries in
combination.
Be sure to use R03 size batteries.
Always remove batteries from remote control if they are
Always remove batteries from remote control if they are
dead or if the remote control is not be used for an extended
period of time. This will prevent battery acid from leaking
into the battery compartment.
period of time. This will prevent battery acid from leaking
into the battery compartment.
Caution
Never throw batteries into a fi re.
Point the remote control at the remote sensor and
press the buttons.
press the buttons.
Distance : About 7 m from the
front of the remote
sensor
sensor
Angle
: About 30° in each
direction of the front
of the remote sensor
of the remote sensor
Open the cover.
Insert batteries.
7 Use 4 batteries (R03 sizes).
7 Make sure to match the + and – on the
7 Make sure to match the + and – on the
batteries to the marks inside the battery
compartment.
compartment.
Close the cover.
1
1
2
2
3
3
Set up the remote control to operate the player and your TV.
Loading batteries
Preparation of the remote control
Operating with the remote control
The remote control has a backlight function for
conveniently illuminating the buttons when you use
the remote control in a dark room, etc.
Lights for approximately 10 seconds when a button
is pressed.
The backlight function is off by default.
To turn on the backlight function
Press and hold
for at least three
seconds.
To turn off the backlight function, press and hold
again for at least three seconds.
Notes
Using the backlight function shortens the lifespan of the
batteries.
The backlight function turns off if the batteries in the
remote control are replaced.
About the remote control backlight
HD-XE1_01_E 16
HD-XE1_01_E 16
06.12.6 2:57:32 PM
06.12.6 2:57:32 PM