Cabletron Systems TRXI-22A ユーザーズマニュアル
INSTALLATION
Page 3-6
3.4
SETTING THE RING SPEED SWITCH
This section explains how to change the TRXI’s ring speed from the
factory default setting of 16 Mbps to 4 Mbps. To change the ring speed,
you need to set the switch located inside the TRXI as shown in
Figure 3-6. You can access the switch through the air vent with a
small screwdriver.
factory default setting of 16 Mbps to 4 Mbps. To change the ring speed,
you need to set the switch located inside the TRXI as shown in
Figure 3-6. You can access the switch through the air vent with a
small screwdriver.
To change the ring speed:
1.
Turn off the TRXI.
2.
Place a small screwdriver through the TRXI’s air vent to access the
Ring Speed Switch.
Ring Speed Switch.
3.
Use the screwdriver to slide the switch to the desired setting as
shown in Figure 3-6.
shown in Figure 3-6.
4.
Turn on the TRXI.
5.
Check that the Ring Speed LED indicates the correct setting.
Figure 3-6. The Ring Speed Switch
DISPLAY
TRXI-24A
TOKEN RING HUB
WITH
LANVIEW®
RING SPEED SWITCH SETTINGS
4 Mbps
16 Mbps
Ring Speed LED Indicator
On = 16 Mbps
Off = 4 Mbps
On = 16 Mbps
Off = 4 Mbps