ICP DAS USA DN-3000 ユーザーズマニュアル

 

 

 

 

There are some parameters within Mitsubishi Drives that must be written to the drive as 2-byte ASCII 
numbers instead of the usual 4-byte ASCII numbers. These parameter numbers need to be entered for 
each drive that requires these “exceptions” to the usual 4-byte ASCII format.  A total of eight (8) 
exceptions may be entered for each drive.

 

 
To enter the exception numbers, move the highlight bar (while in the “EDIT” menu) to the 
“EXCEPTION TABLE” sub-heading and press the ENTER key.  The “EXCEPTION TABLE” screen 
will open with the highlight bar at motor drive zero (0). 

 
 

 

 

Parameter 
Exception  

Entry Area

List of 

Exceptions for 

each Motor 

Drive 

To enter exceptions, press the ENTER, TAB or RIGHT arrow key(s) to move into the Exception Entry 
Area.  Press the SPACE BAR and a “X” will be placed between the brackets of the first exception area 
and a small shaded area will appear to allow entry of the parameter number.  Press the DOWN arrow key 
and the system will move to the next exception entry area.  Repeat all the steps until all exceptions for this 
drive have been entered, then move the highlight to the “SAVE” button and then press the ENTER key.  
After the “Information Saved” screen appears, press the ESC key and the highlight returns to the 
“Drive/Exception List”.  Press the DOWN arrow key once and the highlighted bar will move to the 
second drive in the list.  Repeat all the steps to enter exceptions for each drive and then save this 
information.

 

 

 
 

 

 

NOTE: If all the drives are to have the same exceptions, move the highlight to the “SETALL” 
button and press the ENTER key.  This will allow you to enter the exceptions that will be set for all 
32 drives.

 

Your next step is to transfer this created project file into the DN-3000.  Refer to the section 
“TRANSFERRING PROJECT FILES.”