Intel ZT8101 ユーザーズマニュアル
110
ZT8101 Users Guide
Using the Web Console
IP Address Filtering
You can manually configure the switch to drop packets from specified MAC and IP addresses. For
information about specifying MAC addresses to drop, see the Forwarding | Unicast MAC
Address Setting screen
information about specifying MAC addresses to drop, see the Forwarding | Unicast MAC
Address Setting screen
To specify an IP address for filtering
1. In the left panel, click IP Address Filtering.
2. Click New and configure these fields:
3. Click Apply.
The entry is added to the table.
4. To remove an entry, select the entry in the table and click Remove.
MAC Address Priority
You can specify a MAC address so that packets with this address are given special handling, either
a higher or lower priority than normal traffic.
a higher or lower priority than normal traffic.
Note:
If flow control is enabled, a small of amount of low priority traffic may be forwarded before high
priority traffic.
priority traffic.
To set up a MAC address priority
1. In the left panel, click MAC Address Priority.
2. Click New and configure these fields.
Field
Description
IP Address
Specifies the IP address of the packets you want dropped.
Source/Destination
Specifies the condition for filtering the packets:
•
Destination—Packets with the above IP address as their destination
will be dropped.
will be dropped.
•
Source—Packets with the above IP address as their source will be
dropped.
dropped.
•
Either—All packets with the above IP address will be dropped.
Field
Description
MAC Address
Specifies the MAC address to set a priority for.