IBM 12.1(22)EA6 ユーザーズマニュアル
3-2
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 3 Assigning the Switch IP Address and Default Gateway
Assigning Switch Information
The boot loader provides access to the flash file system before the operating system is loaded. Normally,
the boot loader is used only to load, uncompress, and launch the operating system. After the boot loader
gives the operating system control of the CPU, the boot loader is not active until the next system reset
or power on.
the boot loader is used only to load, uncompress, and launch the operating system. After the boot loader
gives the operating system control of the CPU, the boot loader is not active until the next system reset
or power on.
The boot loader also provides trap-door access into the system if the operating system has problems so
serious that it cannot be used. The trap-door mechanism provides enough access to the system so that if
it is necessary, you can format the flash file system, re-install the operating system software image by
using the XMODEM Protocol, recover from a lost or forgotten password, and finally restart the
operating system.
serious that it cannot be used. The trap-door mechanism provides enough access to the system so that if
it is necessary, you can format the flash file system, re-install the operating system software image by
using the XMODEM Protocol, recover from a lost or forgotten password, and finally restart the
operating system.
Assigning Switch Information
Use the BladeCenter Management Module WEB page to assign IP information to the switch. For more
information, see the IBM BladeCenter QuickStart Guide.
information, see the IBM BladeCenter QuickStart Guide.
If the switch reboots, the switch uses the IP address, subnet mask, and gateway configured in the
stored-configuration file.
stored-configuration file.
This section has this configuration information:
•
•
Default Switch Information
shows the default switch information.
Table 3-1
Default Switch Information
Feature
Default Setting
IP address and subnet mask
10.10.10.9x, where x is the slot number of the switch in
the BladeCenter chassis.
the BladeCenter chassis.
Subnet mask
255.255.255.0.
Default gateway
No default gateway is defined.
Enable secret password
No password is defined.
Hostname
The factory-assigned default host name is Switch.
Telnet username
USERID. You must use all uppercase letters.
Telnet password
PASSW0RD. (Note that 0 is the number zero. You must
use all uppercase letters.)
use all uppercase letters.)