Cabletron Systems 2000 ユーザーズマニュアル

Viewing Chassis Information

2-3

The SmartSwitch 2000 Chassis View

The areas surrounding the device display area provide the following device 
information:

The Internet Protocol address assigned to the SmartSwitch 2000 appears in the 
title bar of the Chassis View window; this Þeld will display the IP address you 
have used to create the SmartSwitch 2000 icon. IP addresses are assigned via 
Local Management.

This color-coded area indicates the current state of communication between 
SPECTRUM Element Manager and the SmartSwitch 2000.

¥

 indicates the SmartSwitch 2000 is responding to device polls (valid 

connection).

¥

 indicates that the SmartSwitch 2000 is in a temporary stand-by mode 

while it responds to a physical change in the hub; note that board and port 
menus are inactive during this stand-by state.

¥

 indicates an unknown contact status Ð polling has not yet been 

established with the SmartSwitch 2000.

¥

 indicates the SmartSwitch 2000 is not responding to device polls (device 

is off line, or device polling has failed across the network for some other 
reason).

The amount of time, in a X days hh:mm:ss format, that the SmartSwitch 2000 has 
been running since the last start-up.

, on 

), this Þeld will show the display currently in effect. 

If only a single port display is available Ñ or if the default view is in effect Ñ this 
Þeld will state Default.

The physical layer address assigned to the interface through which SPECTRUM 
Element Manager is communicating. MAC addresses are hard-coded in the 
device, and are not conÞgurable.

The revision of BOOT PROM installed in the SmartSwitch 2000.

The revision of device Þrmware stored in the SmartSwitch 2000Õs FLASH PROMs.