Cabletron Systems 3T02-04 ユーザーズマニュアル

Using LCM, you can obtain the status of a specific Token Ring port by 
typing 

status <port number>

. (Type 

status

 to display all the ATX port 

numbers.) A sample display of a Token Ring port status is shown below.

ATX >status 7

Port 7 (1st port on module 3) Status

Type: 4Mbps 802.5 Token Ring

Bridging: Source Routing Transparent Bridging (segment=0, 

bridge=0)

Routing: IP Routing

Enabled/Disabled: Bridging/Routing functions enabled

Spanning Tree: Forwarding

Packets Transmitted: 324

Packets Received: 627

Small Buffers: 65

RxQ Overflows: 37

Ring State: Open

Ring Status: No Problems

The status of a Token Ring port includes the following information:

•

Type - whether the ring is operating at 4 or 16 Mbps, and the module 
type, i.e., 802.5 Token Ring.

•

Bridging - which functions have been enabled for bridging (see the 

bridge

 command).

•

Routing - which functions have been enabled for routing (see 

iproute

 

and 

ipxroute

 commands in your NMS manual).

•

Enabled/Disabled - enabled if it is operational, or disabled if you used 
the 

disable

 command to disable it. If the port is enabled but not 

operational, its status will be broken. (A port could be broken if it is so 
badly misconfigured as to be unusable. You might also see a status of 
broken if an FDDI or Token Ring port can’t connect to a logical ring, 
or if an Ethernet port continually fails as it tries to transmit.). Refer to 
your NMS manual for commands.