Juniper Networks 200 ユーザーズマニュアル

Configuring the Device for Telnet and WebUI Sessions

NetScreen-200 Series

25

Allowing Outbound Traffic

By default, the NetScreen-200 Series device does not allow inbound or outbound traffic, 
nor does it allow traffic to or from the DMZ. To permit (or deny) traffic, you must create 
access policies.

The following CLI command creates an access policy that permits all kinds of outbound 
traffic, from any host in your trusted LAN to any device on the untrusted network.

Save you access policy configuration with the following command:

You can also use the Outgoing Policy Wizard in the WebUI management application to 
create access policies for outbound traffic. See 

 for information on accessing the WebUI application.

C

ONFIGURING

 

THE

 D

EVICE

 

FOR

 T

ELNET

 

AND

 W

EB

UI S

ESSIONS

In addition to terminal emulator programs, you can use Telnet (or dialup) to establish 
console sessions with the NetScreen-200 Series device. In addition, you can start 
management sessions using the NetScreen WebUI, a web-based GUI management 
application.

Starting a Console Session Using Telnet

To establish a Telnet session with the NetScreen-200 Series device:

1.

Connect an RJ-45 cable from ethernet1 to the internal switch, router, or hub in 
your LAN (see 

).

2.

Open a Telnet session, specifying the current IP address for ethernet1. For 
example, in Windows, click Start >> Run, enter telnet ip_addr (where ip_addr 
is the address of the ethernet1 interface), then click OK. 

For example, if the current address of the ethernet1 interface is 10.100.2.183, 
enter:

3.

At the Username prompt, type your user name (default is netscreen).

4.

At the Password prompt, type your password (default is netscreen).