Patton electronic 6511RC ユーザーズマニュアル

Model 6511RC User Manual

Matrix Switch test tools

For the purpose of testing and troubleshooting the STM-1 link, the DS0 Mapping definitions, and H.110 bus 
connectivity, the Model 6511RC Matrix Switch offers the following tool sets: 

•

Loopback test modes for the Matrix Switch STM-1 port

•

SDH Section Trace and SDH Path Trace functions for the STM-1 link

The following sections describe these tool sets in detail.

The Matrix Switch provides the following diagnostic loopback test modes for the STM-1 port: 

•

SDH facility loop (see section 

•

SDH terminal loop (see section 

•

H.110 loop (see section 

 on page 90)

The facility and terminal loops are specified by the SDH protocol. The H.110 loop is proprietary to the Fore-
Front Matrix Switch, and fulfills the SDH specification for a third vendor-defined loop. 

Off

There is NO Ethernet frame activity on either of the 10/100/1000 
Ethernet ports. No action recommended

READY

Front 

panel

Blue

On

Indicates module is ready for removal from cPCI chassis.

Off

Indicates module NOT ready for removal from cPCI chassis. 
Do not remove card from chassis.

ALARM

Rear 

blade

Yellow On solid  A minor alarm condition has been detected.

Flashing A major alarm condition has been detected.

Off

The Model 6511RC is operating normally. No action recommended.

READY

Rear 

blade

Blue

On

Card ready for removal from cPCI chassis.

Off

Card not ready for removal from cPCI chassis. 
Do not remove card from chassis.

ON LINE

On

Reserved for future use

Off

Reserved for future use

10/100 
ENET

Front 

Panel

Green On

Ethernet Link is established

Integrated 
LEDs on RJ-
45 connec-
tor

Off

No Ethernet link is established

Yellow On

Flashes to indicates Ethernet frame activity on this port

Off

Indicates no Ethernet frame activity on this port

READY

Blue

On

Card ready for removal from cPCI chassis.

Off

Card not ready for removal from cPCI chassis.

a. This LED provides status indications for the STM-1 WAN link established via the optical or electrical ports on 

the Rear Module of the 6511RC

Table 6. LED status indications and recommended actions (Continued)