DELL 9.8(0.0) ユーザーズマニュアル
Version
Description
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.3.2.0
Introduced on the E-Series TeraScale.
Usage
Information
Information
The VRRP group only becomes active and sends VRRP packets when a link-local
virtual IP address is configured. When you delete the virtual address, the VRRP
group stops sending VRRP packets.
virtual IP address is configured. When you delete the virtual address, the VRRP
group stops sending VRRP packets.
• When VRF microcode is not loaded in CAM, the VRID for a VRRP group is the
same as the VRID number configured with the vrrp-group or vrrp-ipv6-
group command.
group command.
• When VRF microcode is loaded in CAM, the VRID for a VRRP group is equal to
16 times the vrrp-group or vrrp-ipv6-group vrid number plus the ip
vrf vrf-id number. For example, if VRF microcode is loaded and VRRP group
vrf vrf-id number. For example, if VRF microcode is loaded and VRRP group
10 is configured in VRF 2, the VRID used for the VRRP group is (16 x 10) + 2, or
162. This VRID value is used in the lowest byte of the virtual MAC address of the
VRRP group and is also used for VRF routing.
NOTE: Configure the same VRID on neighboring routers (Dell Networking or
non-Dell Networking) in the same VRRP group in order for all routers to
interoperate.
non-Dell Networking) in the same VRRP group in order for all routers to
interoperate.
Related
Commands
Commands
— assigns up to 12 virtual IP addresses per VRRP group.
1910
Virtual Router Redundancy Protocol (VRRP)