Q-Logic SANBOX2-8C ユーザーズマニュアル

4 – Installation

Installing a Switch

59042-00 A

4-13

2.

Enter the Date command and parameters (MMDDhhmmCCYY format) to set 
the system date on the switch.

SANbox2 (admin) $> date 083007512002

<an alarm is displayed that specifies that the switch 

must be reset before the date can be set>

3.

To reset the switch, enter the following command and press the Enter key.

SANbox2 (admin) $> reset switch

Do the following to configure a switch using the SANbox Manager application. 
Refer to the SANbox2 Switch Management User’s Guide for more information 
about configuring a switch. You can also configure the switch using the CLI. Refer 
to 

 for information about the Command Line Interface.

1.

Connect to the switch using an Ethernet connection and run SANbox 
Manager.

2.

Open the Fabric menu and select Add Fabric to open the Add a New Fabric 
window.

3.

Enter a fabric name and the IP address of the switch through which to 
manage the fabric.

4.

Enter an account name and a password and choose the Add Fabric button. 
The default account name and password are (admin, password). If fabric 
security is disabled, account names and passwords are not enforced. Refer 
to the 

 for information about setting 

fabric security.

5.

Open the Switch menu and select Switch Properties. In the Switch 
Properties window, enter a chassis name. Accept the default domain ID, and 
choose the OK button.

6.

Open the Switch menu and select Network Properties. In the Network 
Properties window, enter values for the IP address, subnet mask, and 
gateway address. Accept the default static setting. If you know the SNMP 
configuration settings, enter those as well. Choose the OK button.

7.

Remove the old fabric and add a new one. Add a fabric with the new IP 
address.

Repeat this process for each switch in the fabric, then connect the switches.