Network Technologies UNIMUX-DVI-x ユーザーズマニュアル

 

 

 

Once the UNIMUX is properly connected, the UNIMUX will enable a connection to be made between the CPUs attached to its 
VIDEO and CPU ports and the monitor and input devices attached to the MONITOR and USB Device ports.   The LEDs on the 
control panel of the UNIMUX will illuminate depending on which port (and corresponding CPU) is being connected to the monitor 
and input devices.   
 
The UNIMUX can be controlled by three methods:  

• 

front control panel using touch-switches and LEDs 

• 

keyboard control through Command Mode  

• 

RS232 control (page 12-optional) 

 

 

 

        There is a touch-switch and LED on the front panel of the UNIMUX for each CPU the switch will connect the monitor and 
input devices to.  Pressing any touch-switch on the front panel of the UNIMUX will connect the corresponding CPU to the monitor 
and input devices. 
        Holding down any front panel touch-switch for more than 2 seconds will cause the UNIMUX to cycle through all modes of 
operation including COMMAND, BROADCAST, SCAN, and NORMAL (described in "Command Mode" below).  The three MODE 
LEDs on the front panel indicate which mode is selected.  Release the touch-switch when the LEDs indicate the desired mode.  
When no mode LEDs are illuminated the user is in Normal Mode controlling directly the CPU to which the user is connected 
through the UNIMUX.    

 

 
Keyboard control of the UNIMUX can be achieved using Command Mode (below).    The keyboard can be used to control all 
functions of the UNIMUX as an alternative to using the front panel on the UNIMUX.      
 
By pressing <Ctrl> + < ` > (accent/tilde key),  the user can enter Command Mode.   Once in Command Mode, typing a series of 
commands will cause the UNIMUX to connect the user to any one CPU connected to the switch.   Pressing the <Esc> key will exit 
Command Mode.  
 

In order to control the UNIMUX with the keyboard connected, Command Mode must be enabled.  To enter Command Mode from 
the keyboard:                   

                                           Press                                              

 
 
 
When the COMMAND LED is illuminated, all 3 status lights on the keyboard will illuminate (if they aren't already due to caps lock, 
scroll lock, and/or num lock) to indicate that Command Mode is enabled and the following functions are available:  

 

 

Basic Command Functions 
 
Function:  

       Keystroke: 

 
 
Increment Port  
 
 
 
Decrement Port  
 
 
Toggle Scan Mode 
ON and OFF  
 
 
Toggle Broadcast Mode  
ON and OFF  
 
Sets scan time-out 
period for each port.