National Instruments 1128 ユーザーズマニュアル
Chapter 1
Installing and Configuring the SCXI-1127/1128
© National Instruments Corporation
1-15
Refer to Figure 1-8 to set up this multichassis configuration.
Figure 1-8. 12-Slot to 12-Slot Multichassis Configuration Parts Locator Diagram
1.
Install the HVAB-backplane adapters and jumper blocks in the 12-slot
chassis as described in steps 1 through 3 in
chassis as described in steps 1 through 3 in
2.
Connect the HV8-HV8 cable from the first chassis, normally the
connector behind slot 1, to the HVAB connector (behind slot 12) of the
next chassis.
connector behind slot 1, to the HVAB connector (behind slot 12) of the
next chassis.
3.
Connect the SH9MD-9MD cable from the AUX OUT connector of the
first chassis to the AUX IN connector (behind slot 5) of the next
chassis.
first chassis to the AUX IN connector (behind slot 5) of the next
chassis.
4.
Repeat steps 1 through 3 for each additional chassis.
1
8-Slot HVAB-Backplane Adapter
2
HV8-BAN4 Cable
3
8-Position HVAB Plug
4
2-Slot HVAB-Backplane Adapter
5
1-Slot HVAB-Backplane Adapter
6
NI 4060 for PCI
7
SH9MD-9MD Cable
8
12-Slot SCXI Chassis
9
HV8-HV8 Cable
10 12-Slot SCXI Chassis
11 SH9MD-9MD Cable
11 SH9MD-9MD Cable
AB0+
AB0–
AB2+
AB2–
6
8
9
7
10
1
3
2
11
4
5