3com 5500G ユーザーズマニュアル
Configuring a (Totally) NSSA Area
115
■
Use the display ospf lsdb command on Switch C to display the LSDB. You can
see that no Type-4 LSAs or Type-5 LSAs exist in the LSDB. But Type-7 LSAs and
a Type-7 default LSA are installed.
see that no Type-4 LSAs or Type-5 LSAs exist in the LSDB. But Type-7 LSAs and
a Type-7 default LSA are installed.
Totally NSSA area configuration (area 1 is a totally NSSA area)
Based on the configuration in “Non-backbone area and backbone area
configuration (area 1 is a non-backbone area)” on page 107, perform the
following steps:
configuration (area 1 is a non-backbone area)” on page 107, perform the
following steps:
# Configure area 1 as a totally NSSA area.
[SwitchA-ospf-1-area-0.0.0.1] nssa no-summary
[SwitchC-ospf-1-area-0.0.0.1] nssa
n
■
The steps above configure a totally NSSA area.
■
Use the display ospf lsdb command on Switch C to display the LSDB. You can
see that no Type-3 LSAs, Type-4 LSAs, or Type-5 LSAs exist in the LSDB. But
Type-7 LSAs and a default Type-3 LSA are added.
see that no Type-3 LSAs, Type-4 LSAs, or Type-5 LSAs exist in the LSDB. But
Type-7 LSAs and a default Type-3 LSA are added.
Complete Configuration
n
In the following example, the ASBR of the NSSA area will forward all the packets
destined for other ASs. For the configurations in other cases, refer to
“Configuration Procedure” on page 112.
destined for other ASs. For the configurations in other cases, refer to
“Configuration Procedure” on page 112.
■
Perform the following configuration on Switch A.
#
vlan 100
#
vlan 200
#
interface Vlan-interface100
ip address 10.1.1.1 255.255.255.0
#
interface Vlan-interface200
ip address 10.2.1.1 255.255.255.0
#
ospf 1 router-id 1.1.1.1
area 0.0.0.1
network 10.2.1.0 0.0.0.255
nssa
#
area 0.0.0.0
network 10.1.1.0 0.0.0.255
#
■
Perform the following configuration on Switch B.
#
vlan 100
#
vlan 200
#
interface Vlan-interface100
ip address 10.1.1.2 255.255.255.0
#