3com S330 ユーザーズマニュアル
112
C
HAPTER
4: C
ONFIGURING
P
ATH
B
UILDER
S330/S310 M
ODULES
, P
ORTS
,
AND
A
PPLICATIONS
3 Select [2] Card Information to display the Ethernet Card Configuration menu,
shown in Figure 83. This menu displays the current Ethernet card configuration
and provides an option that allows you to set the administrative status for the
Ethernet card.
and provides an option that allows you to set the administrative status for the
Ethernet card.
Figure 83 Configuring the Ethernet Card
4 Select [1] Set Admin. Status to put the Ethernet card in service or out of service.
Configuring the Bridge
All of the virtual channels assigned to a particular slot and port form a network
bridge. In order to enable the Ethernet port to operate, you must configure the
bridge with the required user-filtering options and an aging timer value.
bridge. In order to enable the Ethernet port to operate, you must configure the
bridge with the required user-filtering options and an aging timer value.
The aging timer value you specify will be listed in the Age column on the List
Forwarding Table. The system deletes station address entries when they have had
no traffic for the specified period of time. To keep addresses in the List Forwarding
table permanently, set the Aging Timer to Permanent. For further details about the
List Forwarding Table, see “Viewing the List Forwarding Table” later in this chapter.
Forwarding Table. The system deletes station address entries when they have had
no traffic for the specified period of time. To keep addresses in the List Forwarding
table permanently, set the Aging Timer to Permanent. For further details about the
List Forwarding Table, see “Viewing the List Forwarding Table” later in this chapter.
To configure the bridge, follow these steps:
1 From the Configuration Management menu, select [3] Manage Bridge to display
the Manage Bridge menu, shown in Figure 84.