3com WX2200 ユーザーズマニュアル

C

HAPTER

 4: U

SING

 RF A

UTO

-T

UNING

You will need to unpack and physically install your WX switches and 
MAPs. For information about installing your equipment, see “Equipment 
Installation” on page 42. 

After installing a WX switch, you must prepare it for configuration and 
management by 3WXM, by configuring IP connectivity between the WX 
and 3WXM. Use the Web Quick Start (if available), or enter the 
quickstart command at the CLI prompt. 

For more information about configuring initial WX switch connectivity, 
see the 

An administrative certificate is also required on the WX switch to enable 
management access by 3WXM. If the switch does not already have 
certificates, MSS automatically generates them the first time you boot 
using MSS Version 4.2 or later. You do not need to install certificates 
unless you want to replace the ones automatically generated by MSS. (For 
more information, see the “Certificates Automatically Generated by 
MSS” section in the “Managing Keys and Certificates” chapter of the 

Upload the WX 
Switch 
Configuration into 
a 3WXM Network 
Plan

Retrieve the basic configuration information you added to the WX switch 
and upload it into 3WXM.

1 Select the Configuration tool bar option.

2 In the Task List panel, select Upload Wireless Switch.

3 In the IP Address box, type the IP address for the WX switch.

4 In the Enable Password box, type the enable password for the WX switch.

This password must match the enable password that was defined using 
the CLI command set enablepass. For more information, see the 

5 Click Next. The uploading progress is shown. 

6 After the Successfully uploaded device message is displayed, click Next.