3com 4200G ユーザーズマニュアル

Static domain name resolution is based on manually configured domain 
name-to-IP address mappings. If you telnet a remote device using its name, the 
local device will look up the corresponding IP address in the static domain name 
resolution table.

Figure 114   Network diagram for static domain name resolution configuration

 

As shown in the above figure, the switch can use static domain name resolution to 
access host 10.1.1.2 through domain name host.com.

# Map host name host.com to IP address 10.1.1.2.

<3Com> system-view

[3Com] ip host host.com 10.1.1.2 

# Execute the ping host.com command to verify that Switch can get the IP 
address 10.1.1.2 of name host.com.

[3Com] ping host.com

PING host.com (10.1.1.2): 56

data bytes, press CTRL_C to break

Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=127 time=3 ms

Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=127 time=3 ms

Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=127 time=2 ms

Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=127 time=5 ms

Reply from 10.1.1.2: bytes=56 Sequence=5 ttl=127 time=3 ms

--- host.com ping statistics ---

5 packet(s) transmitted

5 packet(s) received

Host

10.1.1.1/24

10.1.1.2 /24

host.com

Switch

Switch 5500

Release V03.02.04 

All versions

Switch 5500G

Release V03.02.04 

All versions

Switch 4500

Release V03.03.00 

All versions

Switch 4210

Release V03.01.00 

All versions