3com 4200G ユーザーズマニュアル
98
C
HAPTER
15: R
OUTING
C
ONFIGURATION
G
UIDE
Precautions
■
RIPv2 supports automatic route summarization (with the summary command).
This function is enabled by default.
This function is enabled by default.
■
Based on your needs, you can configure the switch to receive or send RIP
packets with the rip input command or the rip output command.
packets with the rip input command or the rip output command.
■
RIPv2 can transmit packets in two modes: broadcast and multicast. By default,
RIPv2 transmits packets in the multicast mode.
RIPv2 transmits packets in the multicast mode.
Configuring OSPF
Open Shortest Path First (OSPF) is a link state interior gateway protocol developed
by IETF. At present, OSPF version 2 (RFC 2328) is used. OSPF has the following
features:
by IETF. At present, OSPF version 2 (RFC 2328) is used. OSPF has the following
features:
■
Wide-spread application
■
Fast convergence
■
Loop-free
■
Multicast transmission
■
Area partition
■
Routing hierarchy
■
Authentication
Network Diagram
Figure 28 Network diagram for OSPF basic configuration
Device Interface
IP
address
Router
ID
Switch
A
Vlan-int100 10.1.1.1/24 1.1.1.1
Vlan-int200 10.1.2.1/24
Switch
B
Vlan-int100 10.1.1.2/24 2.2.2.2
Vlan-int200 10.1.3.1/24
Switch
C
Vlan-int200 10.1.2.2/24 3.3.3.3
Vlan-int300 10.1.4.1/24
Vlan-int10 192.168.1.1/24
Vlan-int20 192.168.2.1/24
Area 0
Area 1
Switch C
Vlan -int100
Switch B
Switch A
Switch D
Vlan -int200
Vlan -int200
Vlan -int300
Vlan -int10
Vlan-int20
Vlan-int10
Vlan -int20