3com 4500 PWR 50-PORT ユーザーズマニュアル
Logging in Commands
19
auto-execute command
Syntax
auto-execute command text
undo auto-execute command
View
User Interface View
Parameter
text:
Specifies the command to be run automatically.
Description
Enter
auto-execute command text
to configure the Switch to automatically run a
specified command. When the user logs in, the command will be executed
automatically. This command is usually used to configure the
automatically. This command is usually used to configure the
telnet
command on
the terminal, which will connect the user to a designated device automatically.
Enter
undo auto-execute command
to cancel the auto-execute command so the
command is not run automatically.
By default, auto-execute is disabled.
CAUTION: If you execute this command, the user-interface can no longer be used
to perform routine configurations on the local system. Ensure that you can log in
to the system in some other way to cancel the configuration, before you configure
the
to perform routine configurations on the local system. Ensure that you can log in
to the system in some other way to cancel the configuration, before you configure
the
auto-execute command
and save the configuration.
Example
To configure the Switch to automatically Telnet to device 10.110.100.1 after the
user logs in via VTY 0, enter the following command:
user logs in via VTY 0, enter the following command:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]user-interface vty 0
[4500-ui-vty0]auto-execute command telnet 10.110.100.1
command-privilege level
Syntax
command-privilege level level view view command
undo command-privilege view view command
View
System View
Parameter
level:
Enter the command level you want to assign to this command, ranging
from 0 to 3.
view:
Enter the name of the view that contains the command. This can be any of
the views supported by the Switch.
command:
Enter the command to be configured.