Enterasys Networks 6H3xx ユーザーガイド

Setting the Module Login Password provides additional security by assigning each switch module 
its own password and allowing you to disable the function of switch S8 so that the password 
cannot be cleared. To assign the password and disable switch S8, proceed as follows:

1. Use the arrow keys to highlight the appropriate Password field. A different password can be 

assigned to each Access Policy.

2. Press ENTER.

3. To disable the function of switch S8 so the passwords cannot be cleared, use the arrow keys to 

highlight the Switch 8 field.

4. Press the SPACE bar to select DISABLED.

5. To save the settings, press ENTER. The message “SAVED OK” displays at the top of the screen.

To configure the Radius client in the switch to restrict access to the management functions of the 
Local Management screens, by way of the COM port or network TELNET connection.

This screen allows you to set the necessary parameters to centralize the Authentication, 
Authorization, and Accounting of the network resources. For information about Radius Client and 
how it functions, refer to 

 and 

NOTE: The configuration and enable state of the Radius client will be stored in NVRAM 
and loaded on power-up. If the client is properly configured and enabled, the platform 
will create the Radius client and enable it at boot time, superseding legacy 
authentication. Otherwise, the legacy authentication becomes operational.

Radius Client parameters can also be set using the Network Tools screen described in