Enterasys Networks B2G124-24 ユーザーズマニュアル
Installing the Switch on a Flat Surface
3-6 Hardware Installation
3.
, push in on the release tab as far as it will go to release
, pull
out on the release tab to release the Mini‐GBIC from the port slot.
4.
Grasp the sides of the Mini‐GBIC and pull it straight out of the port slot.
If storing or shipping a Mini‐GBIC, which has a fiber‐optic connector, insert its protective
dust cover to protect the ends of the fiber‐optic fibers from dust or contamination.
dust cover to protect the ends of the fiber‐optic fibers from dust or contamination.
Installing the Switch on a Flat Surface
When installing the switch on a flat surface, the installation of the rubber feet is
recommended to prevent the switch from sliding on a flat surface. Installing the rubber
feet is optional if you are installing the switch in a rack. To install the rubber feet, proceed
to “
recommended to prevent the switch from sliding on a flat surface. Installing the rubber
feet is optional if you are installing the switch in a rack. To install the rubber feet, proceed
to “
” instructions below. For instructions to rack mount the
switch, proceed to “
Installing the Rubber Feet
To install the rubber feet, refer to
and proceed as follows:
1.
Place the switch on its back on a sturdy flat surface to gain access to the bottom of the
chassis.
chassis.
2.
Remove the four rubber feet from their plastic bag in the shipping box.
3.
Locate the four marked locations on the bottom four corners of the chassis.