Enterasys Networks B2G124-24 ユーザーズマニュアル
Connecting to Console Port for Local Management
3-18 Hardware Installation
Connecting to Console Port for Local Management
This section describes how to install an RS232 DTE interface cable to a PC, a VT series
terminal, or a modem to a SecureStack B2G124‐24, B2G124‐48, or B2H124‐48 for out‐of‐
band sessions using CLI commands.
terminal, or a modem to a SecureStack B2G124‐24, B2G124‐48, or B2H124‐48 for out‐of‐
band sessions using CLI commands.
What Is Needed
The following is a list of user‐supplied DTE interface cables that may be needed to connect
the DB9 male Console port connector on the switch. The cables are terminated by a DB9
female connector at one end, and by one of three type connectors at the other end,
depending on the type connection needed for the remote device. The cables that may be
needed are as follows:
the DB9 male Console port connector on the switch. The cables are terminated by a DB9
female connector at one end, and by one of three type connectors at the other end,
depending on the type connection needed for the remote device. The cables that may be
needed are as follows:
•
DB9 female‐to‐DB9 female
•
DB9 female‐to‐DB25 female
•
DB9 female‐to‐DB25 male
Using a DTE modem DB9 female‐to‐DB9 female cable, you can connect products
equipped with a DB9 DTE male console port to an IBM or compatible PC running a VT
series emulation software package.
equipped with a DB9 DTE male console port to an IBM or compatible PC running a VT
series emulation software package.
Using a DTE modem DB9 female‐to‐DB25 female cable, you can connect products
equipped with a DB9 DTE male console port to a VT series terminal or VT type terminals
running emulation programs for the VT series.
equipped with a DB9 DTE male console port to a VT series terminal or VT type terminals
running emulation programs for the VT series.
Using a DTE modem DB9 female‐to‐DB25 male cable, you can connect products equipped
with a DB9 DTE male console port to a Hayes compatible modem that supports
9600 baud.
with a DB9 DTE male console port to a Hayes compatible modem that supports
9600 baud.
The cable used must connect the Console port Received Data, Pin 2 to the Transmitted
Data pin at the other end of the cable. The connection from the Console port Transmitted
Data, Pin 3 (must be connected) to the Received Data pin cable connection at the other end
of the cable. The DB9 Console port pin assignments are shown in
Data pin at the other end of the cable. The connection from the Console port Transmitted
Data, Pin 3 (must be connected) to the Received Data pin cable connection at the other end
of the cable. The DB9 Console port pin assignments are shown in
.
Note: When switches are connected in a stack configuration and all high-speed stacking
cables are connected before powering up the switches, one switch in the stack will be
automatically designated as the Manager of the stack and its Console port will remain
active. All other switches will become Member switches and their Console ports will be
deactivated.
cables are connected before powering up the switches, one switch in the stack will be
automatically designated as the Manager of the stack and its Console port will remain
active. All other switches will become Member switches and their Console ports will be
deactivated.