Extron electronic MAV 48 ユーザーズマニュアル
Operation, cont’d
MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
3-8
Example 1: Create a set of video and audio ties
The following steps show an example in which input 5 is tied to outputs 3, 4, and 8.
The example shows the front panel indications that result from your actions.
The example shows the front panel indications that result from your actions.
This example assumes that there are no ties in the current configuration.
1
.
Audio/video switchers only
— Select video and audio for the tie (figure 3-4).
I/O
AUD
VID
Press the button to cycle
through the selections.
The video LED lights when video is selected.
The audio LED lights when audio is selected.
Figure 3-4 — Select video and audio
2
.
Press and release the Input 5 button (figure 3-5).
7
6
5
2
4
1
INPUTS
8
3
Press and release the Input 5 button.
The Input 5 LED lights to indicate that input 5 is selected.
Figure 3-5 — Select an input
3
.
Press and release the Output 3, Output 4, and Output 8 buttons (figure 3-6).
The entire set of ties can be canceled at this point by waiting for the 5-second
input/output button timeout to occur.
input/output button timeout to occur.
7
6
5
2
4
1
8
3
OUTPUTS
Press and release the Output 3, 4, and 8 buttons.
The LEDs blink to indicate that the selected input will be tied to these outputs.
= Blinking LED
Figure 3-6 — Select the outputs
4
.
Press and release the Enter button (figure 3-7).
ENTER
3
4
8
5
INPUTS
OUTPUTS
The selected input's and the selected outputs'
LEDs light steadily for approximately 1
second to indicate the tie and then go out.
LEDs light steadily for approximately 1
second to indicate the tie and then go out.
Press the Enter button to
confirm the configuration
change.
confirm the configuration
change.
1 second
Figure 3-7 — Press the Enter button