Extron electronic MAV 48 ユーザーズマニュアル
3-27
MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
Optimizing the Audio (Audio/Video Switchers)
Each individual input audio gain can be adjusted within a range of -18 dB to +10 dB
to eliminate noticeable volume differences between sources and to achieve the best
headroom and signal-to-noise ratio. Adjust the audio level as follows:
to eliminate noticeable volume differences between sources and to achieve the best
headroom and signal-to-noise ratio. Adjust the audio level as follows:
1
.
Connect audio sources to all desired inputs and connect the audio outputs to
output devices such as audio players. See “Audio input and output
connections (audio/video models)”, in chapter 2, “Installation”. For best
results, wire all of the inputs and the outputs balanced when possible.
output devices such as audio players. See “Audio input and output
connections (audio/video models)”, in chapter 2, “Installation”. For best
results, wire all of the inputs and the outputs balanced when possible.
2
.
Power on the audio sources, the switcher, and the audio players.
3
.
Apply audio signals to all inputs to be optimized.
4
.
In Audio Setup mode (see “Adjusting input audio gain and attenuation”, on
page 3-19) select among the inputs while observing the front panel Power
LED. The LED blinks at a rate that corresponds to the highs and lows of the
audio signal.
page 3-19) select among the inputs while observing the front panel Power
LED. The LED blinks at a rate that corresponds to the highs and lows of the
audio signal.
5
.
As necessary, adjust the audio gain of each input so that the Power LED
blinks frequently for all selected inputs. If the LED is lit most of the time, the
level is probably too high; if the LED rarely flashes, the level is too low.
blinks frequently for all selected inputs. If the LED is lit most of the time, the
level is probably too high; if the LED rarely flashes, the level is too low.
As an alternative:
•
If necessary, temporarily set the output 1 level to the consumer (-10 dBV)
level (see the Audio output level SIS commands in chapter 4, “Remote
Operation”).
level (see the Audio output level SIS commands in chapter 4, “Remote
Operation”).
•
Measure the output 1 audio level (in Audio Setup mode, the selected input
is tied to output 1) with test equipment, such as a VU meter, or listen to
the output 1 audio with a critical ear.
is tied to output 1) with test equipment, such as a VU meter, or listen to
the output 1 audio with a critical ear.
Troubleshooting
This section gives recommendations on what to do if you have problems operating
the MAV Series switcher.
the MAV Series switcher.
1
.
Ensure that all devices are plugged in and powered on. The switcher is
receiving power if the power LED is lit.
receiving power if the power LED is lit.
2
.
Ensure an active input is selected for output on the switcher.
3
.
Ensure that the proper signal format is supplied.
4
.
Check the cabling and make corrections as necessary.
5
.
Call the Extron S
3
Sales & Technical Support Hotline if necessary.